approach path

英 [əˈprəʊtʃ pɑːθ]

美 [əˈproʊtʃ pæθ]

进场航线

电力

英英释义

noun

• the final path followed by an aircraft as it is landing
  Synonym:approachglide pathglide slope

双语例句

• Thereinto, the research about non-FIFO network provides a new approach for least time path problem in non-FIFO network.
  所提出的非FIFO网络最短路径理论为解决非FIFO网络最短时间路径问题提供了新的途径。
• Aim at current existent problems and defects in visual approach slope indicator, a new Precision Approach Path instruction method has studied.
  针对现有目视进近下滑坡度指示系统存在的问题和缺陷，研究了一种新型精密进近航道指示方法。
• The problems of the approach glide& down path holding and longitudinal control are particularly discussed. At the same time, the ways to calculate the feedback control loop parameters for automatic flight control system and approach power compensator system are given.
  着重讨论了舰载飞机在进场下滑过程中的轨迹保持及其纵向控制，同时给出了此时飞机的飞行自动控制系统和进场功率补偿器系统反馈控制参数的计算方法。
• Ms. Hersman stressed that there was 'no prior distress call' from the cockpit crew, which should have been able to rely on both ground-based and onboard landing aids to 'establish an approach path' to safely reach the beginning of the runway.
  赫斯曼强调说，驾驶舱内的机组人员事发前没有发出遇险信号。机组成员原本应该能够依靠地面上和飞机上的着陆辅助系统建立一条降落通道，安全到达跑道的起点处。
• An efficient approach of the shortest path algorithm which is based on Dijkstra algorithm is realized. A motorcade-optimized dispatching software is realized.
  用Dijkstra算法实现了城市中两点间最短路径搜索，在此基础上，实现了基于电子地图的大型车队优化调度及管理的系统软件。
• In this paper a graphic approach to the path planning problem based on the topological method is discussed.
  本文提出一个解决基于拓扑的路径规划问题的新途径：图形法。
• An Efficient Approach to Complete Coverage Path Planning and its Application to a Cleaning Robot
  完全遍历路径规划方法及其在清洁机器人中的应用
• 4-1-4 polynomial is used to approach the path that is divided into three segments.
  使用4－1－4次多项式分3段对点到点的运动进行逼近。
• This paper describes a new approach to robot path planning: the transition cost matrix based approach.
  本文描述了机器人路径规划的一种新方法：基于转移费用矩阵的机器人路径规划方法。
• Finally, a new approach for cutter path calculation using binary-search technique is presented, which will simplify the CNC programming problems to a great extent.
  最后提出一种采用对分试算法计算刀具轨迹的新方法，可简化数控编程计算问题。